Victron MultiPlus 48/800/9-16 230V VE.Bus 48V Inverter

The new MultiPlus 48/800/9-16 (Victron Energy, pmp481800000) is the successor to the Multiplus Compact 48/800. This unit is an advanced device combination consisting of a powerful pure sine wave inverter, an advanced 9a battery charger utilizing adaptive charging technology, and a 16a high speed AC transfer switch.

In the event of a mains fault or, if shore power or on-board generator is interrupted, the multi's inverter is automatically switched on and takes over the supply to the connected loads. The switching occurs so quickly (in less than 20 milliseconds) that uninterrupted operation of computers and other electronic equipment is guaranteed.

• Cont. Output power at 25°c: 700w / 800w at non-linear load
• Victron Energy mpn: pmp481800000
• for 48v system voltage
• integrated 9a mains charger for your batteries
• integrated 16a mains transfer switch
• USV operation possible
• Extensive accessories available
• Can be used in numerous applications, whether on land or mobile

The complete bridging additionally with a ring transformer topology has proven itself for years. The inverter is short-circuit proof and protected against overheating (whether caused by overload or ambient temperature)

The Multi Control remote control panel can be used to set the maximum mains or generator current to be drawn. The MultiPlus then takes into account other connected AC consumers and uses only the current that is "left over" for charging. This prevents the generator or shore power connection from being overloaded

Load peaks often only occur for a limited period of time. In such a case, the MultiPlus ensures that insufficient shore power or generator output is immediately compensated for by energy from the battery. If the load is reduced, i.e. if consumers are switched off, the energy that is then sufficiently available again can be used to charge the batteries

This is required for switching on loads with high inrush currents, such as voltage converters for LED lamps, halogen lamps or power tools

When the search mode is set to 'on', the current consumption of the inverter is reduced by approximately 70% during no-load operation. In this mode, when operating in inverter mode, the Multi will shut down at zero load or at only light load and turn back on for a short period every two seconds. if the output current exceeds a set limit, the inverter resumes operation. If this is not the case, the inverter switches off again

In the default setting, the multifunction relay acts as an alarm relay, i.e. it switches off the device in the event of faults (device becomes too hot, ripple voltage at the input too high, battery voltage too low)

Scope of delivery:

Victron Energy pmp481800000, MultiPlus 48/800/9-16