Kemo m240 power controller 230 v/ac, 10 a, multifunction
The kemo m240 is a power controller for 230 v/ac loads such as motors, lamps, many dimmable LEDs, etc. The controller is overload proof and can be controlled by a potentiometer, by a control voltage or by pwm signals.
Control options
- Potentiometer 100 k lin
- Control voltage 0-10 V/DC
- pwm signal 3 - 24v, 100-10.000 Hz
Technical data
- Operating voltage: 220-230 v/ac, 50-60 Hz
- Max. connectable load: 10a (2.300W)
- Control mode: phase angle control
- Switch-on: soft start
- Operating indication, overload indication: 2-color LED
- Control signal input is completely isolated from the load control loop
- Connections: Plug contacts flat plug 6,3mm and 2,8mm
- Dimensions: approx. 87 x 60 x 33 mm
Installation instructions:
The module is installed in such a way that it is well ventilated (it may heat up, depending on the load) and that it is isolated (no possibility of contact with fingers or other body parts. There are open connections that carry mains voltage). The module should be installed close to the device to be controlled (max. 2m). The aluminum base plate of the module should not get hotter than 60°C. If the module is loaded <800w, no additional heat sink is required. For loads between 800w - 2300w the module should be screwed with the aluminum base plate on a cooling base. The module has 8 spade connectors with which it can be connected: 4 x 2.8mm spade connectors and 4 x 6.3mm spade connectors.
Scope of delivery:
1x kemo m240 230v power controller
Manufactuerer Information
Kemo Electronic
Kemo-Electronic GmbH
Leher Landstr. 20
27607 Geestland
Germany
Mail: info@kemo-electronic.de
Tel.: +49 4743 93380