KEMO Rain Sensor 12V

Product number: 2-12-0M152K

5% Rabatt mit Code BLACKWEEKS24 im Warenkorb sichern

Shipped in 1-3 days

€40.28*

Prices incl. 19% VAT plus shipping costs

Product number: 2-12-0M152K

Similar Products

KEMO Rain Sensor 12V

€24.00*

If the sensor plate gets into contact with rain or slushy snow / hail, it switches on a relay. Sun blinds may be retracted with that, skylights may be...

Shipped in 1-3 days

kemo water detector 9 - 12 v dc

€9.69*

When the 2 sensor connections of the module come into contact with water, the built-in relay switches on. This can be used to control sirens, other sh...

Shipped in 1-3 days

If the sensor plate gets into contact with rain or slushy snow / hail, it switches on a relay. Sun blinds may be retracted with that, skylights may be closed or a simple rain alarm can be given. The automatically heated surface of the sensor prevents any freezing or wetting of the sensor surface. 2 installed LEDs indicate the function. Waterproof-encapsulated electronics.

Note: The electronics of the rain sensor reacts to the electrical conductivity of the water. We have now ascertained that there are areas where rainwater falls, which is absolutely clean (distilled water). The sensor does not react to this. The water must be at least slightly contaminated (fractions of dust, smoke, etc.) so that the water is electroconductive and triggers the sensor. In Germany the rainwater is conductive in 99% of the areas. If the sensor does not trigger in your case, you should install it in such a manner that the rainwater runs at first over a small porch roof or the like before the water touches the sensor. If the water falls directly from the cloud on the sensor in its purest form and does not trigger it, it will be sufficient if it runs over a small board or from a porch roof on the sensor. Then the water will have absorbed enough impurifications that it will be electroconductive and triggers the sensor. Of course, the sensor has to be built it slantwise so that the water runs down again.

Technical data:

Operating voltage: 12 V/DC
Current consumption without / with heating: ca. 8 / 160 mA
Relay contact: 1 x ON, maximum load 25 V, 2 A
Sensor heating automatically in case of contact with rain
Light-emitting diode 1 indication that the rain sensor works
Light-emitting diode 2 indication that rain is reported and the relay has switched on
Duty cycle of the relay as long as the sensor is wet
The module is encapsulated waterproof.
Active sensor surface, gold-plated: ca. 29 x 30 mm
Dimensions: ca. 65 x 45 x 36 mm

Bedienungsanleitung_M152.pdf Download

Manufacturer: Kemo Electonic

Operating voltage: 12 V/DC

Manufactuerer Information

Kemo Electronic

Kemo-Electronic GmbH
Leher Landstr. 20
27607 Geestland
Germany

Mail: info@kemo-electronic.de

Tel.: +49 4743 93380

Your name / alias

Your eMail

Product question

Publish question

Fields marked with asterisks (*) are required.

I have read and accepted the privacy notice.

This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.

No questions have been asked about this article yet.

Loading products

KEMO Rain Sensor 12V

Manufactuerer Information

Subscribe to the newsletter